Technical & Reference Section > Tech and Restoration

how to prep for ano - advise needed?

(1/3) > >>

20to26:
What's the best way to prepare brake levers for re-anodising?

Should I sand down the scratches with 1500 grit wet & dry?

20to26:
thanks Glen, is this the case generally?

Haro82:

--- Quote from: 20to26 on June 17, 2010, 09:20 PM ---thanks Glen, is this the case generally?

--- End quote ---

I got some suntour beartrap cages redone. I prepped one of them and they did the other.

I wish I had got them to do both  :-[ 

20to26:
I need a pair of levers and calipers done - I see in this pic that the levers seem to have been done with the pivot pin still in - I'm presuming that that's not a problem then:



As for the calipers - the little steel bit at the top of the arm has been removed - how the heck do you get that sucker out?

Haro82:
That is usually nut/bolted in isn't it ? Do you not just undo it? 

Navigation

[0] Message Index

[#] Next page