Technical & Reference Section > Tech and Restoration

Pedal fitting

(1/4) > >>

wildon:
Trying to get these Hutch minis onto TA arms... the left went on with a bit more force than i should have used i think but the right aint going on at all.  It just about connects but then is just too tight to screw in.  I've cleaned the threads on both but still no good.  Pedals are 9/16's and other pedals screw on no problems.
I think its a problem with the pedals but what can i do?!  :-\

billstup:
You are putting them on the right arms I take it, the drive side has the normal right hand thread, and the left arm has the left hand thread  :daumenhoch:

wildon:

--- Quote from: billstup on December 30, 2010, 04:41 PM ---You are putting them on the right arms I take it, the drive side has the normal right hand thread, and the left arm has the left hand thread  :daumenhoch:

--- End quote ---

Yep, they are defo on the right arms.  The left is on, although it did wind out some metal from the arms while screwing in  :-\

bof:
Sounds like you have screwed the left one into the right hand one to me . have a look at the spindle is there a letter stamped on it . are you sure you have a right and left pedal are you sure you have a right and left crank arm ?

wildon:

--- Quote from: bof on December 30, 2010, 05:53 PM ---Sounds like you have screwed the left one into the right hand one to me . have a look at the spindle is there a letter stamped on it . are you sure you have a right and left pedal are you sure you have a right and left crank arm ?

--- End quote ---

No, they are defo the right way.   I have screwed it into some flights, it's tight but does go.  and i've screwed other pedals into the crank arm no problems.  I compared the threads with others and they look the same.. and there aint no damage to them.  Can't frickin work it out   :-\

Navigation

[0] Message Index

[#] Next page