Technical & Reference Section > Tech and Restoration

acs boa 16mm nut to 10mm thread conversion.raaaa PICS ADDED

<< < (3/4) > >>

dan-dare:
and use a centre punch before drrrrrrriiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiilllllllllllllllllllllllllllllllllllllllllllllllllllllliiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiinnnnnnnnnnnnnnnnnnnnnnnnnnnnnnggggggg.  :angel:

energiza:

--- Quote from: dan-dare on February 11, 2011, 09:46 PM ---and use a centre punch before drrrrrrriiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiilllllllllllllllllllllllllllllllllllllllllllllllllllllliiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiinnnnnnnnnnnnnnnnnnnnnnnnnnnnnnggggggg.  :angel:

--- End quote ---
:daumenhoch:i need to invest in one m8..lol

GTnumber1:

--- Quote from: dan-dare on February 11, 2011, 09:46 PM ---and use a centre punch before drrrrrrriiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiilllllllllllllllllllllllllllllllllllllllllllllllllllllliiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiinnnnnnnnnnnnnnnnnnnnnnnnnnnnnnggggggg.  :angel:

--- End quote ---


+ 1  :daumenhoch:

Betty:
Chemical metal? Is that some sort of glue?

You'd trust a brake thats been glued together...  :idiot2:

energiza:
 ::) lol i forgot to say in above posts.that the drilled hole as to be tap n di.ed out.so there is a thread inside to screw the 6mm thread into.the chemical metal is a kinda glue.but its made from 2 tubes of stuff that react together when applyed to any metal source.creating a bond as strong as a weld.almost like metal.this was squeezed into hole then 6mm thread screwed in after.so should be strong enough

Navigation

[0] Message Index

[#] Next page

[*] Previous page