Technical & Reference Section > Tech and Restoration

acs boa 16mm nut to 10mm thread conversion.raaaa PICS ADDED

<< < (4/4)

bof:
11mm drill bit


dirt bike brake slot for 6mm spindle


drill in position



hole drilled brake installed 5 minutes later

energiza:
 :'( owwwww poor frame.i could.nt drill a frame out just for a brake.ouchhhh

Betty:

--- Quote from: energiza on February 12, 2011, 01:55 PM --- ::) lol i forgot to say in above posts.that the drilled hole as to be tap n di.ed out.so there is a thread inside to screw the 6mm thread into.the chemical metal is a kinda glue.but its made from 2 tubes of stuff that react together when applyed to any metal source.creating a bond as strong as a weld.almost like metal.this was squeezed into hole then 6mm thread screwed in after.so should be strong enough


--- End quote ---

Makes more sense now...  :daumenhoch:

Bof's method takes the win though...  :4_17_5:

bof:
The dirt bike deserves no sympathy.  :LolLolLolLol:
but a brake that works far outweighs damage that can be done from a flipped manual  :daumenhoch:

Navigation

[0] Message Index

[*] Previous page