Technical & Reference Section > Tech and Restoration

How to remove a stuck stem ?

(1/3) > >>

defjam:
I have got a problem removing a stem that is stuck in to the forks.

It is an anodised red SR stem, the forks are ASCO and it is a TA frame.

I have tried WD40 and wiggling the handlebars left and right.  Nothing gives.

Removed the bars and top plate, covered stem with towel and applied a few liberal whacks with a hammer and large adjustable spanner.  Towel ripped a bit and a couple of dings in the stem, but it is still in there solid. 

Loosened headset to try both of the above again, no joy. :'(

The bike is in decent nick and everything else is ok, there is no sign of rust at all.

Anyone have any suggestions please as all I can think of is applying more brute force  :knuppel2:

Cheers

Rich :daumenhoch:

harris:
have you turned bike upside down put long thin bar throu fork hole and hit as hard as poss
punch it out that way.

bodamus:
Yes what Harris said turn it upside down get a long thin bar and whack it. I had the same problem before where someone had used the wrong wedge and it was jammed in there tight. This was the only way I could get it out.

Good Luck ;)

defjam:
Hi Mate,

That is a new one on me.  Will give it a go.

More brute force  :knuppel2:

Cheers

Rich :daumenhoch:

harris:
mind your hand n fingers dont be shy hit it hard be carefull.

Navigation

[0] Message Index

[#] Next page