Technical & Reference Section > Tech and Restoration

Bolts on Pinchless

<< < (3/3)

Devilock:

--- Quote from: diesel on July 16, 2012, 09:35 PM ---Halfords do a slim range of sockets - I have one for this very purpose  :daumenhoch:

--- End quote ---

You wait ages for a bus then...........!!!  :D

Well ill take a trip to Halfords! Show me a pic of yours please if possible ...& the socket...!!!!  ;D

oldtired:
will a proper crank puller tool not fit ?   they have 14 / 15mm  double ended socket and also a thread in puller for the arms :daumenhoch: 

Frosty:
As the above says, get a crank puller because you are likely going to need it to get the 400 arm off the tapered spindle anyway! Or you'll end up getting a hammer out, which may have been acceptable in the 80's but not on those cranks now :2funny:

oldtired:
 :LolLolLolLol:      yup don't want to be hammering them off,       puller tool is one of those tools when you use one for the first time you think "why the fook didn't i buy one of these years ago"    :LolLolLolLol:

Navigation

[0] Message Index

[*] Previous page