Technical & Reference Section > Tech and Restoration

Elegant solutions to a bashy problem.

<< < (2/9) > >>

ED209:
I'm prepared for anything  :)

I was thinking of cutting a chunk out of the bars of the bash bit to shorten it, stick something inside to join them up again, then drill and bolt it on behind the BB.

It will never be 'bashed' so it doesn't have to be super strong  :)

griff:

--- Quote from: ED209º on September 14, 2012, 03:31 PM ---
It will never be 'bashed' so it doesn't have to be super strong  :)

--- End quote ---

Got some blue-tack if that's any good to ya?

pickle:
What a pile of wank design!

jimwise68:

--- Quote from: ED209º on September 14, 2012, 03:31 PM ---It will never be 'bashed' so it doesn't have to be super strong  :)

--- End quote ---

Ed, then whats the point of doing it?  ???  :LolLolLolLol:

Discostu:
I've got say. I think you are mad. Your butchering a perfectly good frame to make it look like something else.  :idiot2:
I would sell it on and look for a wal riot. Then get new dropouts made that support the seat stays better.  :daumenhoch:

Navigation

[0] Message Index

[#] Next page

[*] Previous page