Technical & Reference Section > Tech and Restoration

How to strip black MX 1000's ( update now with pics )

(1/5) > >>

benno:
I've had em sat in nitromors for a few days and its not touched it !
Are they anodised black ? Is it an oven pride job ?
:) :)

brummie:
yep anno ya wally
fook me don't leave them in it too long tho kid

CustardLips:

--- Quote from: brummie on September 10, 2013, 10:37 PM ---yep anno ya wally
fook me don't leave them in it too long tho kid

--- End quote ---
x2 or nail varnish remover and a cotton wool pad (takes a bit longer tho and a bit more elbow grease needed).  :daumenhoch:

benno:
Cheers  :buck2:

dancetothedrummersbeat:
About 5 mins in oven pride should do the trick, but keep checking regularly. Don't leave them in for any longer than necessary. I usually remove after a minute or so, run the parts under a tap & wipe off to remove the gloopy stuff, then re-submerge and repeat. 5 mins should be more than enough. Polish up with autosol, and behold - a mint looking caliper  "wantit"

Navigation

[0] Message Index

[#] Next page