Technical & Reference Section > Tech and Restoration
Lacing Peregrine 48h, The spirit of manliness…..
sprocket:
More than half the thread left. Nipples are just lightly screwed on ( 3 turns each ). Great info on the holes direction. I was looking at that and wondering if that makes any difference. Thanks for the help guys. I will give it a go again after NY :popcorn:
GavinDavis:
Always start with the 1st spoke going in the hole on the right hand side of the valve hole :)
But apart from that, good work :daumenhoch:
garran:
thats a mighty fine effort. i looked on u tube for some help. cant say i'm an expert as i've only done it 3 times myself , 3x, then 4x on the same wheel ::) and then radial spoked. tidy
john4130:
--- Quote from: GavinDavis on December 29, 2013, 08:44 PM ---Always start with the 1st spoke going in the hole on the right hand side of the valve hole :)
But apart from that, good work :daumenhoch:
--- End quote ---
i always start with the first hole to the left of the valve hole, and if it's a rear hub the drive side should be facing down when you start.
East Coast Bmx:
Good firstime effort m8y... :daumenhoch:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version