Technical & Reference Section > Tech and Restoration

Lacing Peregrine 48h, The spirit of manliness…..

<< < (3/5) > >>

peteox:
Almost there.. But turn rim two spoke holes - either direction. If you got spoke cross over above valve hole then the spokes are in the wrong holes.. And you will damage the nipples! Also I would be surprised if 183mm will be long enough to lace 4X

sprocket:

--- Quote from: peteox on December 29, 2013, 05:57 PM ---Almost there.. But turn rim two spoke holes - either direction. If you got spoke cross over above valve hole then the spokes are in the wrong holes.. And you will damage the nipples! Also I would be surprised if 183mm will be long enough to lace 4X

--- End quote ---

www.ozbmx.com.au : "Peregrine Speedline 48 Hoop, Peregrine Loose-ball High Flange Hubs, 4x, tall nipples, 184mm.. "

183 seems to be working though? Off coarse, wheel is not tight yet and I'm not sure i am using "tall nipples". did i just said tall nipples  :bow:

sprocket:
right, here it is now. 4x, 183mm



I think I hear a tiny voice in my head sending me to the LBS  :loser:

solow79:
Have they been tightened yet? Can I see threads from the spokes?

peteox:
Looks like you might just get away with 4X, You may end up with a little bit of thread showing once tightened? I have identical set up with 184mm laced 3X. Problem is you still have spoke cross over above valve hole so need to rotate rim two holes around. If you look very closely at the holes you will find that not only are they handed but they are angled out of the dome to point to either side of the hub (side on). The nipples are being bent over the wrong way out of hole in pics. Apart from that they look right!! Hope this helps

Navigation

[0] Message Index

[#] Next page

[*] Previous page