BMX General > BMX Chat

Bit of tyre advice needed.

(1/8) > >>

kungfunky:
Been thinking about a project for a couple of years but done nothing about it  :-[ until now  :D

I'm going to need some low rolling resistance tyres, knobbly joblies are way too lumpy for what I need. Ideally they need to be pre 86. Any decent suggestions ?

Also some super smooth rolling hubs,  ceramic bearings would be sweet but not sure which ones.

oldschoolace:
You want something a little different Ash? What about something like a laser Trac tyre?

kungfunky:

--- Quote from: oldschoolace on September 08, 2015, 09:15 PM ---You want something a little different Ash? What about something like a laser Trac tyre?

--- End quote ---

Those the ones with the thick grey strip down the middle ?..

oldschoolace:
Yep. Think bendycat had some a while back 

kungfunky:
Thinking about it are they also a wheel chair tyre ?.. They could work well I think.

Navigation

[0] Message Index

[#] Next page