Technical & Reference Section > Tech and Restoration

Potts bolt issue?

<< < (3/3)

deeman:

--- Quote from: SAFRANEV6RXE on December 25, 2015, 08:13 PM ---All done took my time and now the potts bolt is fitted..
Had a NOS ACS gyro given to me today aswell but not sure if it will fit my Burner?,looks great but not sure if its going to fit?
I was going to go down the route of longer cables and the potts bolt setup,a pic of the exact way the cable should be routed and fixed to the front caliper would be handy.

--- End quote ---

You need to route it down the inside or outside of the fork and loop it up to reach your caliper. You will probably need to hold it in place with a tie or two or Velcro straps. I will get a pic of mine tomorrow for you if you are still stuck. What caliper do you have? Has it been modded to accept the cable upside down?  The ACS Rotor will fit no problem, you just need to run the stem a bit higher to allow for the travel of the rotor. There should be plenty of images on the net of rotors set up. They are not brilliant and can be a pain to set up but you should be able to achieve decent stopping power with a bit of fiddling  :daumenhoch:

SAFRANEV6RXE:
Thanks for the advise look foward to a pic to help.
I messed about with the adjusters yesterday and everything seemed to fit fine.

Navigation

[0] Message Index

[*] Previous page