Technical & Reference Section > Tech and Restoration

Potts bolt issue?

<< < (2/3) > >>

SAFRANEV6RXE:
Thanks chaps,just looking at it theres a sleeve at the top about 5mm can that be drafted out from the inside or is it a drill job only?

BMX1973:

Some stems only need 1-2mm drilled out to fit the potts mod bolt.  :)

rodriguez:
Fire a pic or two up before you do anything   :daumenhoch:

SAFRANEV6RXE:
All done took my time and now the potts bolt is fitted..
Had a NOS ACS gyro given to me today aswell but not sure if it will fit my Burner?,looks great but not sure if its going to fit?
I was going to go down the route of longer cables and the potts bolt setup,a pic of the exact way the cable should be routed and fixed to the front caliper would be handy.

bobbbbsy:
 ^"^ burnerlove

Navigation

[0] Message Index

[#] Next page

[*] Previous page