Technical & Reference Section > Tech and Restoration
1984 Gen 1 Haro Sport Finished
In2bmx:
Here is what info I have found .
Hi Carl , the sport you have bought is the 1st generation and probably the only Sport to ever where the signature Mike Dominguez on the chain stays as I believe these were only made by Torker over maybe a 4 month run as the 2nd gen was released with the tapered stays in Aug 84.
The 1st gen sport has non tapered tubing unlike any other 84 sport, same as the 1st Master .
Mike left Haro summer 84 to hutch, which meant any sport after this time had Bob Haro signature on the chain stays
1st gen- Torker/non taper
2nd gen.- Torker/ thin taper
3rd gen- tai made/ tapered with chevrons stamped in gusset
factory pilot:
Great info Carl :4_17_5:
This is going to be some build ... As you know I'm quite partial to anything Haro related ::)
Retrodan72:
Nice parts collected so far Carlos. Are you planning on doing custom decals on the white, or sticking with factory colour's, or is it a big secret and you're planning a reveal? ???
In2bmx:
--- Quote from: Retrodan72 on September 04, 2016, 06:50 PM ---Nice parts collected so far Carlos. Are you planning on doing custom decals on the white, or sticking with factory colour's, or is it a big secret and you're planning a reveal? ???
--- End quote ---
OG decals . With the grey stripe cut round the gusset like it should be :daumenhoch:
Retrodan72:
--- Quote from: in2bmx on September 04, 2016, 07:10 PM ---
--- Quote from: Retrodan72 on September 04, 2016, 06:50 PM ---Nice parts collected so far Carlos. Are you planning on doing custom decals on the white, or sticking with factory colour's, or is it a big secret and you're planning a reveal? ???
--- End quote ---
OG decals . With the grey stripe cut round the gusset like it should be :daumenhoch:
--- End quote ---
Nice, I do like the grey. :crazy2:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version