Technical & Reference Section > Tech and Restoration
1984 Gen 1 Haro Sport Finished
dancetothedrummersbeat:
--- Quote from: in2bmx on September 04, 2016, 06:25 PM ---Here is what info I have found .
Hi Carl , the sport you have bought is the 1st generation and probably the only Sport to ever where the signature Mike Dominguez on the chain stays as I believe these were only made by Torker over maybe a 4 month run as the 2nd gen was released with the tapered stays in Aug 84.
The 1st gen sport has non tapered tubing unlike any other 84 sport, same as the 1st Master .
Mike left Haro summer 84 to hutch, which meant any sport after this time had Bob Haro signature on the chain stays
1st gen- Torker/non taper
2nd gen.- Torker/ thin taper
3rd gen- tai made/ tapered with chevrons stamped in gusset
--- End quote ---
Great info, thanks Carl. Like i said, i know nothing about these but it's good to know the differences with them
NORTY40:
Awesome frameset Carlos :smitten: 8)
Im sure you will do it justice , looking forward to the updates ;)
deeman:
--- Quote from: in2bmx on September 04, 2016, 06:25 PM ---Here is what info I have found .
Hi Carl , the sport you have bought is the 1st generation and probably the only Sport to ever where the signature Mike Dominguez on the chain stays as I believe these were only made by Torker over maybe a 4 month run as the 2nd gen was released with the tapered stays in Aug 84.
The 1st gen sport has non tapered tubing unlike any other 84 sport, same as the 1st Master .
Mike left Haro summer 84 to hutch, which meant any sport after this time had Bob Haro signature on the chain stays
1st gen- Torker/non taper
2nd gen.- Torker/ thin taper
3rd gen- tai made/ tapered with chevrons stamped in gusset
--- End quote ---
To add to this the Gen 1 had the coaster tab BELOW the chainstay, same as Masters and also the Gen2 and 3 had a swage line at the bottom of the rear dropouts....
Redline:
MK17 Show and Shine Winner coming right up :D
Jaymz:
This is warming up nicely, although I would've preferred a nice opc instead of 3 piece
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version