Technical & Reference Section > Tech and Restoration

Coaster brake question

<< < (2/2)

MartyC:
A 10 or 15mm bolt, washer and nyloc nut should do, the sort of thing you can pick up fom B&Q  :daumenhoch:

Rombloke:

--- Quote from: jezza on September 16, 2006, 12:09 AM --- so wot nuts and bolts do i need,

--- End quote ---

ones that fit in the hole, i think they are normally a 6mm bolt and a nyloc nut

Dave

jimwise68:
good luck with the coaster!  :laugh:

I had one on my TA that I bought early this year. Always wanted one BITD cos I thought it looked cool for rollbacks.

Anyway took my bike out for a ride went to bunnyhop up a kerb levelled my pedals ready for the jump, but had to pedal back to level. You guessed it, stopped almost dead front wheel clipped the kerb and nearly threw me off.

I got home and immediately ordered a freewheel convertor from Alans.

jezza:

--- Quote from: jimwise68 on September 16, 2006, 01:48 PM ---good luck with the coaster!  :laugh:

I had one on my TA that I bought early this year. Always wanted one BITD cos I thought it looked cool for rollbacks.

Anyway took my bike out for a ride went to bunnyhop up a kerb levelled my pedals ready for the jump, but had to pedal back to level. You guessed it, stopped almost dead front wheel clipped the kerb and nearly threw me off.

I got home and immediately ordered a freewheel convertor from Alans.

--- End quote ---

 :LolLolLolLol: :LolLolLolLol: :LolLolLolLol:

oh the joys  ;D

Navigation

[0] Message Index

[*] Previous page