Technical & Reference Section > Tech and Restoration

Profile Cranks Installation - Tool required?

<< < (2/2)

HUTCHMAN:
Perhaps get a piece of round bar stock aluminium or brass to drift the spindle out if removal is required in the future. Rubber mallet or piece of hard wood and hammer for fitment.

Mikku:
Thanks Dave! I only ever had opcs bitd and the Crupi has a 2-piece crank, so I'm popping my 3-piece cherry with these Profiles! :D

Mikku:
Thanks to more help from Dave (thanks mate), my cherry is now well and truly popped! Had to resort to a hammer and blocks of wood at both ends of the spindle to get the driveside arm on but the non-drive side arm just needed a rubber mallet. Pictorial evidence over in the main thread! :daumenhoch:

Navigation

[0] Message Index

[*] Previous page