Technical & Reference Section > Tech and Restoration
Removing seat clamp - advice
Retrodan72:
It will come off if you let us bum you.
Swivel:
--- Quote from: Retrodan72 on May 20, 2020, 11:33 AM ---It will come off if you let us bum you.
--- End quote ---
What a group bum again? I'm still recovering from the last one :surprise:
Swivel:
--- Quote from: VOIVOD on May 20, 2020, 10:32 AM --- :) I`ve removed a few similar clamps-not with any finesse (I used a chisel on the spot welds) and just peeled them off.Did no damage other than what wa sleft of the weld had tro be filed/sanded down & then used a regular clamp.A Dremel should do a much tidier job .
--- End quote ---
That was my plan, i'm nervous but I will give it a go this evening :daumenhoch:
Swivel:
--- Quote from: Taipan on May 20, 2020, 10:18 AM ---I've done a few of these but all I can say is some came off easy and some wont budge for example the ones that worked I was able to Dremel off the spot welds on the back of the clap where the bolt sits and with a bit of force with a screw driver of similar it popped off :daumenhoch: but a couple of others even after removing the little spot welds they would not budge? :( so Its a case of try it tentively? ??? just my experience fella someone may know different?
--- End quote ---
I'm gonna try with a screwdriver first, also a dremel. Thanks for the reply, I'll give it a go this evening :daumenhoch:
Retrodan72:
--- Quote from: Swivel on May 20, 2020, 12:27 PM ---
--- Quote from: Retrodan72 on May 20, 2020, 11:33 AM ---It will come off if you let us bum you.
--- End quote ---
What a group bum again? I'm still recovering from the last one :surprise:
--- End quote ---
Anything you post on this forum, should ALWAYS result in you receiving a bumming.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version