Technical & Reference Section > Tech and Restoration

Profile crank bearing spacer tube?

<< < (3/4) > >>

Moose:
Solving the problem is not an issue - I just wanted to know why I have two pairs with a tube that's too short?

Too long, that I can understand, but too short is just stoopid  :idiot2:

I've found the answer anyway  :daumenhoch:

LXIX:
and it is?

Dingobmxer:

--- Quote from: LXIX on February 25, 2007, 04:28 PM ---  :wtf:  cut a new tube same dia different lenght ,spacers are only for the drive end to get your chain lazer straight,did you people race bikes?

--- End quote ---

at least we know the difference between a spacer tube and a Euro/US BB  :LolLolLolLol:

 :) DINGO :)

Dingobmxer:
AND I always find the drive side spacer too wide to get a good chainline so use the very thin washers that come with redline cranks, and I pop the bearing seals out and pack the bearings with good quality grease because Profile bearings come with virtually no grease in them  :uglystupid2:
 :) DINGO :)

Moose:

--- Quote from: LXIX on February 25, 2007, 05:40 PM ---and it is?

--- End quote ---

There are two lengths for USA BB 51mm & 53mm.

Navigation

[0] Message Index

[#] Next page

[*] Previous page