Technical & Reference Section > Tech and Restoration

tuf neck stem help and mx1000 question

<< < (2/3) > >>

sawzall:
my one has a 19mm nut between flats of nut,the best thing to do is turn the nut until the flat face faces stem :daumenhoch:

Steve P:

--- Quote from: dj_benice on August 24, 2007, 03:54 PM ---cheers, any tips on removing the bolt, am built like a racing snake ;)

--- End quote ---

Tuf Neck "Ace" stem ... very nice  :coolsmiley:

The quill looks off centre in your pics ... undo the main bolt by clamping an old set of bars or a seat post in the stem

Align the quill making sure the taper sits central under the stem. Tighten the main bolt as tight as possible and make sure the flats are across the stem to clear the top cap

Use heat to help straighten the caliper arm

Hope that helps  :daumenhoch:

Steve

dj_benice:
cheers, will give it a whirl and see how get on :)

Steve P:
Here's a pic of one of my NOS stems to show the main nut position when set  :daumenhoch:



Steve

dordymush:
put a bit of heat on the big nut if its very tight.
my last one was a pig to get out.

Navigation

[0] Message Index

[#] Next page

[*] Previous page