BMX General > BMX Chat

will a bench vice be anygood for pressing bearing cups in?

<< < (3/4) > >>

adenough:
nice bars, what make are they? ::)

Dark Diggler:
Flatland them, bet he knocked in the bearings with a hammer and wood though  :LolLolLolLol:

Dingobmxer:

--- Quote from: adenough on September 20, 2007, 08:22 PM ---nice bars, what make are they? ::)

--- End quote ---

cant remember?
changed them now for something with a little more "sweep"  :coolsmiley:

 :) DINGO :)

Moose:
Don't forget the soft jaws, so that you don't damage those anodised headset cups  :daumenhoch:

rarman1:

--- Quote from: Dingobmxer on September 20, 2007, 08:04 PM ---Heathens  :2gunsfiring_v1:



 :) DINGO :)

--- End quote ---

i recently made something like this with some threaded rod, 2 washers, 2 nuts and 2 3"x 3" 10mm plates which were offcuts from a metal works place around the corner to me, cost me £7 to make, let me know if you want me to post a pic and i'll take one tomorrow for you ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page