Technical & Reference Section > Tech and Restoration

How to rattle can spray a f/f.. what do i need?

<< < (3/3)

oberonspacefruit:
not pricey,but it is hard work.

superbikedan:

--- Quote from: sawzall on March 06, 2008, 07:31 PM ---remove old paint with paint stripper then sand down with 500-600,then degrease and a light dusting of etch primer,2 or 3 coats of high build primer wet flat with 800 -1000 wet and dry,degrease again then spray 1 light coat and finish with a couple of wet coats ;)

--- End quote ---

 :idiot2:  ;D is that some kind of old pre war type finish, fasinating :shocked:  no seriously, good luck with it,

it's all in the prep, so one tip, dont worry how the primer looks, if the frames pited or small dings, flood it on then

flat it off following the shape of the tubes, it will come out perfect :daumenhoch:

Navigation

[0] Message Index

[*] Previous page