Technical & Reference Section > Tech and Restoration

How to rattle can spray a f/f.. what do i need?

<< < (2/3) > >>

MartyC:

--- Quote from: scary_leary on March 06, 2008, 07:26 PM ---lol.. powders sooo last year
dodgy hung in the garage covered in dust fooked up runny paint finishes are back.. :daumenhoch:

--- End quote ---

Dan wet sprays too  :LolLolLolLol:

adeshere:
Warmth :-)

Dont do it when its damp outside as it just wont harden properly

oberonspacefruit:
put the cans in hottish water.


its all in the sanding. you can spray any old shit. if you cut the paint right, it will be mirror.

adeshere:
Also clear lacque to finish

scary_leary:

--- Quote from: sawzall on March 06, 2008, 07:31 PM ---remove old paint with paint stripper then sand down with 500-600,then degrease and a light dusting of etch primer,2 or 3 coats of high build primer wet flat with 800 -1000 wet and dry,degrease again then spray 1 light coat and finish with a couple of wet coats ;)

--- End quote ---

cheers Phil

sounds pricey and hard work  :LolLolLolLol:

Navigation

[0] Message Index

[#] Next page

[*] Previous page