Technical & Reference Section > Tech and Restoration

info on falcon pro!!

<< < (2/3) > >>

djgivvinup:
You don't have to do anything about the bearings mate, the only part of the headset thats altered is the cups..grinding the part of the cup that sits in the frame doesn't affect where the bearings sit in the cups or any other part of the headset.
Basically grind some off the cups, so they sit in the frame tightly, then fit the rest of the headset like you would normally.

Hope that makes sense  :LolLolLolLol:

jT Racing:
or you could just get  the next size down if it's a smaller size, they use them on race bikes(drophandels and the likes) are we talking a huge difference? they are either right or a different size, they were never easy to get into cheap assed frames anyhow.

djgivvinup:
i seriously hammered the crap out of all the headsets i tried, but not one of them would go in. I thought i was gonna break the frame with the welly i was giving it   :LolLolLolLol:

Simonoid:
 :LolLolLolLol:

cheers Chaps

Simonoid:
Had a go at that but still need some bearing's can you get them anywhere?

Navigation

[0] Message Index

[#] Next page

[*] Previous page