BMX General > BMX Chat

Holeshot RF1

<< < (8/45) > >>

magna13:
Dont Know? Doesnt Look Like It

harris:
i do hope he doesnt get the sand paper out on it.

magna13:

--- Quote from: harris on June 19, 2008, 06:07 PM ---i do hope he doesnt get the sand paper out on it.

--- End quote ---

 :(

dannywhiteley:
Imagine if he removes the decals to give it a proper clean

lodge:
All the the frames i remember had a gyro tab on the right hand side of the headtube also the gap between the top tubes and bottom tube where they meet the headtube is much wider on the frame shown.
I am 99% sure Bernie Vincent made all the Holeshot frames, now his welding was far from great but much neater than on the frame shown.
I dont wanna dampen the enthusiasm for this find but had to highlight these points.

Navigation

[0] Message Index

[#] Next page

[*] Previous page