BMX General > BMX Chat
Holeshot RF1
magna13:
--- Quote from: dannywhiteley on June 19, 2008, 06:14 PM ---Imagine if he removes the decals to give it a proper clean
--- End quote ---
i'd be upset as they are the originals
bmxer4ever:
--- Quote from: Trev on June 19, 2008, 05:32 PM ---I'm pretty sure it was Bernie Vincent that made them.
Andy R told me they only made about 150 of them. Neil probably broke a lot of them.
I imagine they would have been as strong (or weak) as the Vincent Air Zone, and there aren't many of them left either.
--- End quote ---
Well, he would have gettin' up to this kinda malarky on it...
magna13:
:shocked: :shocked:
Neil Looking Good
PHIPPSIO:
--- Quote from: stevemcintosh on June 19, 2008, 06:23 PM ---All the the frames i remember had a gyro tab on the right hand side of the headtube also the gap between the top tubes and bottom tube where they meet the headtube is much wider on the frame shown.
I am 99% sure Bernie Vincent made all the Holeshot frames, now his welding was far from great but much neater than on the frame shown.
I dont wanna dampen the enthusiasm for this find but had to highlight these points.
--- End quote ---
Like this gyro tab?
harris:
yep spot on that
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version