Technical & Reference Section > Tech and Restoration

grips on?

<< < (3/4) > >>

pickle:
never had an issue with WD40, spray a little in the grip and bang em on....dry in minutes  :daumenhoch:

JT71:
WD40 for getting em on and off. 100% success rate here.

to get em off use the little red tube to inject the wd40 down the grip, squidge it around and off it slides.

to get em on, spray the inside of the grip and the outside of the bars both with WD40, squidge em around to even out the wd40 and let em dry.

Dex Dexter:
Hairspray - never fails.  Would never do anything else.

Small amount inside the grip - on it goes - dry in 24 hours in a warm house.

When you want the grips off - lift the side up with a small plastic rod or something - bit more hairspray in - off they come.

Never ever had a problem.

P.s. - the wife uses Elnet - or at least she did till I wasted it all on grips!

telelogic:

--- Quote from: Dex Dexter on December 19, 2008, 09:43 AM ---Hairspray - never fails.  Would never do anything else.

Small amount inside the grip - on it goes - dry in 24 hours in a warm house.

When you want the grips off - lift the side up with a small plastic rod or something - bit more hairspray in - off they come.

Never ever had a problem.

P.s. - the wife uses Elnet - or at least she did till I wasted it all on grips!

--- End quote ---

there is no wife is there?

I know we are all about old school here, but you have to give up the hairspray mullet!

Put the can on the ground, And back away slowly ;D

sweetbeats:
i just lightly spray with water, job done :daumenhoch:
same to take them off.

Navigation

[0] Message Index

[#] Next page

[*] Previous page