Technical & Reference Section > Tech and Restoration

Flippin' ACS Rotor....

<< < (2/2)

g_lamb:

--- Quote from: thebigdog on July 20, 2009, 11:22 AM ---Move the top cable mount from where it is to round the side above the bottom one and see if that is ever better

--- End quote ---


--- Quote from: gary4130 on July 20, 2009, 12:08 PM ---yeah the top +lower cables need to be in line to get a better pull on the brake -the only problem is if you turn your bars +try braking also  >:( .mine i had fitted didn't work very well when bars were turned 180  :P

--- End quote ---


--- Quote from: cheekythirtysix on July 20, 2009, 01:19 PM ---Yeh.. line em up fella... mine works fine when lined up  :daumenhoch:

--- End quote ---

Most kind. Will have a play 2nite and I'll let you know whether I took the adjustment tool to it or not  :D

Cheers fella's :daumenhoch:

adeshere:
I guess thats why the gyro's were better as they pulled evenly from both sides

gary4130:
too true mate ,spent too much time messing about with both a spinmaster 1 +acs rotor trying with little success to get the damm things to work ok  :tickedoff: >:( :'(

Wadz:
i had a gyro on my rider and couldnt get any good brake pressure , turned to acs rotor and acs boa front and rear calipers
now there sh!t hot ,mine dialed in straight away ,make sure you outer cables arent over  long and you  oil the stem shaft,
my cables mounting  arent aligned, my top one is like yours straight off the back of the stem and the lower is set so the cable run down
the side of the top (as close as poss with out touching)
 

Navigation

[0] Message Index

[*] Previous page