Technical & Reference Section > Tech and Restoration

1/18 stem removal

<< < (2/3) > >>

Gary72:

--- Quote from: Glen on September 06, 2009, 05:57 PM ---problem is a grind disk wont fit in the groove in the stem

--- End quote ---
A dremel one should; If you can get at it with a hacksaw then a dremel should be no problem.

lazychubs:
put the other bolt back in and really tighten it
then wack a torq bit into the rounded off one
should come undone then .

kev-s:
turn the bike upside down and whilst holding the bars off the floor twat the bottom of the stem with a rubber mallet, once the stem is off all the pressure on the rounded out bolt should be released making it easier to remove

Gary72:
What worked?

kev-s:
if in doubt give it a clout :daumenhoch: :daumenhoch: :daumenhoch:

Navigation

[0] Message Index

[#] Next page

[*] Previous page