Technical & Reference Section > Tech and Restoration

Removing powdercoat for raw finish advise

(1/2) > >>

lodge:
After some advise please, I want to remove some powdercoat from some n/s forks/bars to have a raw finish, whats the best way to achieve this and what clearcoat should i apply to the raw finish?
Cheers in advance.

Del:
here you go:-

http://www.radbmx.co.uk/forum/index.php'topic=54500.0

meticulous:
remember, if the powders did it properly the steel underneath will have been shot blasted and will be a very course finish, similar looking to sand paper, and wouldnt look right just being laquared... ;)

Bettyswallocks:

--- Quote from: Del on December 06, 2009, 07:27 AM ---here you go:-

http://www.radbmx.co.uk/forum/index.php'topic=54500.0

--- End quote ---

Gonna give that a go later...  :daumenhoch:

tolaknawris:

--- Quote from: Betty on December 06, 2009, 12:02 PM ---
--- Quote from: Del on December 06, 2009, 07:27 AM ---here you go:-

http://www.radbmx.co.uk/forum/index.php'topic=54500.0

--- End quote ---

Gonna give that a go later...  :daumenhoch:

--- End quote ---


how did you get on Mark?  ::)

Navigation

[0] Message Index

[#] Next page