Technical & Reference Section > Tech and Restoration

Removing powdercoat for raw finish advise

<< < (2/2)

Bettyswallocks:

--- Quote from: Random ginger raver! on December 24, 2009, 04:58 PM ---
--- Quote from: Betty on December 06, 2009, 12:02 PM ---
--- Quote from: Del on December 06, 2009, 07:27 AM ---here you go:-

http://www.radbmx.co.uk/forum/index.php'topic=54500.0

--- End quote ---

Gonna give that a go later...  :daumenhoch:

--- End quote ---


how did you get on Mark?  ::)

--- End quote ---

Got as far as going to the local car spares place and they didnt have any in stock

Then forgot about it... lol

I'll have a look for some while im off work

Redline:

--- Quote from: meticulous on December 06, 2009, 07:45 AM ---remember, if the powders did it properly the steel underneath will have been shot blasted and will be a very course finish, similar looking to sand paper, and wouldnt look right just being laquared... ;)

--- End quote ---

I disagree Sammy.... if the powders do it properly they should clean the bare metal up by hand prior to powdercoating..... frames weren't shot blasted back in the day!

Best if you can get the frame chemically stripped to retain the original metal finish.... then a nice polish up  :daumenhoch:

Navigation

[0] Message Index

[*] Previous page