Technical & Reference Section > Tech and Restoration

Torker Fork/Headset problem

<< < (4/4)

FuNMoNsTeR:
Thanks guys.... i have mailed the guy i got it from and asked him to look in the crown cone for the shim... He says its not there and that it was loose when he had it :( All this after being told by him that the headset fitted snugly and that he had no problems ::)
 i am sure i have the words tawt elbillug  tattooed on my forehead. I wondered why it said gullible twat when i looked in the mirror this morning ;D
 I have found a solution....check this out :D
I have a NOS floor mop... old school stylie with the white wooly mop bit and the plate and ring that the wooden handle slots into. The ring is exactly the thickness i need and is almost the right diameter ;D  It is split down one side anyway so i can open it up a few mm. I have hacked a ring off and put the mop back so the missus will never know  :angel:
 The Torker build goes on :2gunsfiring_v1:
Thanks again guys ;)

daz bmx it!:
Hey Andy,all them years watching Blue Peter were'nt wasted after all ;)

FuNMoNsTeR:
 :LolLolLolLol:

And you win a Blue Peter badge..... Get down Shep :D

I had to file the ring down today...it took about 2 hours to get it right and fit....but the jobs a good un. Tighter than a virgin with her legs crossed :daumenhoch:

Navigation

[0] Message Index

[*] Previous page