Technical & Reference Section > Tech and Restoration

A bit of help / advice needed please

(1/5) > >>

Jamroll:
So been tightening up all the bits on the CW tonight for its maiden voyage tomorrow in the sun and have come across a bit of an issue  >:(

I have a set of twin pinch redlines fitted to her at the moment and here lays the issue, on the driveside i have the bottom bracket then the top hat washer that fits nice and snug to a tuff neck power disc which has a tuff neck chain wheel fitted to it.



It just seems to be to far out, and because of this the chain is MEGA close to the frame down by the freewheel, now i've turned the crank a couple of times and the allignment is well off the chain is catching the teeth on the free wheel and just cant be ridden the way it is.


I've tried moving the rear wheel as far forward into the rear dropouts as far as they can but not helping the situation.
Apart from mounting the Chainwheel on the back of the powerdisc (I think this was done on the dp prototype) is there any other way i can sort this???
Doing my haed on this.
Thanks in advance  :daumenhoch:
Al

rollin72:
im sure the top hat washer needs to go on the other side of the disk

Gnarlyscoots:
The chainring needs to go the other side of the power disc bro  :daumenhoch:

rollin72:
the chainring's on the right side, im sure its the tophat washer :-\

griff:
on my haro had a slight alignment problem but swapped the spacers around as one was bigger than the other (before it sounded like it was in the middle of 'changing gear' if you know what I mean)

got my tophat washer on same way as you

btw your bike looks fookin ace Al

Navigation

[0] Message Index

[#] Next page