Technical & Reference Section > Tech and Restoration

14mm axle to fit 10mm forks?

<< < (2/3) > >>

ED209:
or grind the axles down yourself  :)

I've done 2 sets with an angle grinder and if you go steady its fine  :daumenhoch:

Dannywhac:

--- Quote from: ED209º on April 26, 2012, 02:06 PM ---or grind the axles down yourself  :)

I've done 2 sets with an angle grinder and if you go steady its fine  :daumenhoch:



--- End quote ---

Tis a hollow axle though unfortunately Ed :)

ED209:

--- Quote from: dannywhac on April 26, 2012, 02:08 PM ---
--- Quote from: ED209º on April 26, 2012, 02:06 PM ---or grind the axles down yourself  :)

I've done 2 sets with an angle grinder and if you go steady its fine  :daumenhoch:



--- End quote ---

Tis a hollow axle though unfortunately Ed :)

--- End quote ---

hollow smollow... get the GRINDER OUT  :D

Hellcat:
Nice pics.

I don't have a grinder, I'll try some local body shops and see what they say.

Dannywhac:
That is a point - if the axle wall thickness is 3mm you could get away with it - that'd leave 1mm thickness after shaving.

Navigation

[0] Message Index

[#] Next page

[*] Previous page