BMX General > BMX Chat

Vector bars ? ? ? ?

<< < (5/6) > >>

glenboy:

--- Quote from: Pioneer on January 14, 2013, 11:05 AM ---
Not sure Ash :-\

You may have to remove lever and grips to check the top bar angle and rad on the top bends

Genuine article



--- End quote ---

yours have been massively cut down as they should be about 31 inch wide

Pioneer:

--- Quote from: glenboy on January 14, 2013, 08:42 PM ---
--- Quote from: Pioneer on January 14, 2013, 11:05 AM ---
Not sure Ash :-\

You may have to remove lever and grips to check the top bar angle and rad on the top bends

Genuine article



--- End quote ---

yours have been massively cut down as they should be about 31 inch wide

--- End quote ---

Yes thats why the tape was across them but the reference is to the shape of the cross bar......

Devilock:

--- Quote from: monkeybiscuits! on January 14, 2013, 04:20 PM ---
--- Quote from: Jaan on January 14, 2013, 04:17 PM ---Send the picture to 12elvemonkeys on the museum - he'll know for sure  :daumenhoch:

--- End quote ---

Or send the pic to 12 monkeys, one will surely guess right  :LolLolLolLol:

--- End quote ---

 :LolLolLolLol:

Jaan:

--- Quote from: monkeybiscuits! on January 14, 2013, 04:20 PM ---
--- Quote from: Jaan on January 14, 2013, 04:17 PM ---Send the picture to 12elvemonkeys on the museum - he'll know for sure  :daumenhoch:

--- End quote ---

Or send the pic to 12 monkeys, one will surely guess right  :LolLolLolLol:

--- End quote ---

 :LolLolLolLol: collectively, no singularly, they'll know more than me that's for sure

BENDYCAT ELEVENTEEN:
so no one is going to answer Ash ?  ???  if you don't YOU WILL ANSWER TO HIM  :knuppel2:

Navigation

[0] Message Index

[#] Next page

[*] Previous page