Technical & Reference Section > Tech and Restoration

Dent filling?????

<< < (2/4) > >>

buzzlightyear05:
What temp do the ovens run at dan??

aditup 2234:

--- Quote from: Moschops on May 21, 2009, 10:57 PM ---Can you braze Ally then???

Forgive my ignorance, I did a little metal work at skool but that was a while ago.

--- End quote ---

Not sure, but I dont think the alloys will "mix" or "take"
And there is an issue as to which has the highest melting point?
Ad

superbikedan:

--- Quote from: buzzlightyear05 on May 21, 2009, 10:59 PM ---What temp do the ovens run at dan??

--- End quote ---

i bake most of my powder at 180c but some are 200c :)

buzzlightyear05:
Thats milliput out of the window then lol. Ive got a set of bars and they have had a few dents filled with milliput thats all.

Moschops:

--- Quote from: aditup 2234 on May 21, 2009, 11:07 PM ---
--- Quote from: Moschops on May 21, 2009, 10:57 PM ---Can you braze Ally then???

Forgive my ignorance, I did a little metal work at skool but that was a while ago.

--- End quote ---

Not sure, but I dont think the alloys will "mix" or "take"
And there is an issue as to which has the highest melting point?
Ad

--- End quote ---

Yeah that was my thought.

I think an ally frame needs to be filled with ally.

Braze takes to steel like a duck to water, but I think the ally would melt before the braze.

Navigation

[0] Message Index

[#] Next page

[*] Previous page